Here is a status update of my CNC and what I have done.
As you can see I have now add the sides to the cabinet and with a small extra
table on the front.
Here is the extra table on the front, it is handy with some extra space for
putting parts when working.
The hole where the cable chain is connected has been made a bit bigger because
it was too small for the cables that I plan to get through the hole.
Add a cable channel to guide the cables from the CNC and into the cabinet, it is
made so it can move when the CNC is working and it is very easy to take apart if
I have to remove the CNC from the cabinet.
Here you can see the cable channel has the cables hidden in it and the cover on,
there is missing the endplate that I donít have now but will add later on.
Here is a view at the inside of the cabinet with the PC and the cables coming in
from side just behind the PC, the cables will later on be connected to the
electronics enclosure at the backend of the cabinet.
Here is a view of the backend with the electronics enclosure.
If you look at my YouTube
channel then there is a video where I show the progress and goes a bit more
into details it
So now I am basically finish with the cabinet below the CNC and I can now begin
to work on installing the new electronics and replace the cabling and sensors.
Thanks for watching