Welcome to my website


Archive
CNC Progress at April 2014 - Power meter and electronics
15 April 2014 22:09
I have now installed a power meter on my CNC so that I can see how much Kwh I use to cut a part and by this know how much it cost.
The power meter is a 3 phase Schneider Electric PM750MG power meter, the meter has an RS485 serial port so you can read all the data from it, but for now I have not connected thatů maybe later on.

Here is power meter put into a narrow box because the space is limited.

Here you can see the power meter in the box is installed in the tiny space next to the enclosure.


To see more details then look at my you tube video her http://youtu.be/3R-NnDlL_2s


Tooms @ 15 April 2014 22:09 | Comment | Direct link


Arkive list
2015 - November
2014 - August
2014 - April
2014 - March
2014 - February
2014 - January
2013 - December
2013 - November
2013 - October
2013 - August
2013 - June
2012 - December
2012 - September
2012 - August
2012 - May
2012 - April
2011 - November
2011 - October
2011 - September
2010 - May
2010 - March
2010 - January
2009 - December
2009 - November
2009 - October
2009 - August
2009 - July
2009 - May
2009 - April
2009 - March
2009 - February
2009 - January
2008 - December
2008 - November
2008 - August
2008 - January
2007 - December
2007 - November
2007 - October
2007 - August
2007 - July
2007 - April
2007 - March
2007 - February
2007 - January
2006 - December
2006 - November
2006 - September
2006 - August
2006 - July
2006 - May
2006 - April
2006 - March
2006 - February
2006 - January
2005 - December
2005 - November
2005 - October
2005 - September
2005 - August